My roller throttle tube kit will fix your misalignment issues with your dual carb cross bar linkage. It comes with instructions and mounting hardware. Part #703 the price is $64.00 shipped in the USA , $68.65 with CA sales tax. Cable, cable end, and barrel clamp NOT included. See product photo gallery for more pics. ***The roller tube is to be used with braided cables***

This kit gets rid of that ugly hole in your fan shroud. It is made from aluminum and has a stainless steel tip. It comes with instructions and mounting hardware. It is designed to be used with linkages that line up with the stock cable hole, not for use with cross bar linkages. Cable, cable end, barrel clamp NOT included. Part #704 the price is $39.00 shipped in the USA, $41.73 shipped to CA with CA sales tax. See product photo gallery for more pics.

Stainless steel decklid props, lathe faced ends , clean bends, very high quality. I make two models one for "W" decklids 57 and earlier and my "regular" prop for 58 and later. A prop will not work with rain catchers. These are not the cheapest prop on the market but they are the nicest. Price is $30.00 + shipping. I ship these via USPS priority mail, your shipping cost in the USA will be $7.00  See more pics in the product photo gallery.

Part # 701W for 57 and earlier

Part # 701R for 58 and later 

I make these in 1/8, 3/16, 1/4, and 3/8 of a inch. Part #709+size the price is $14.00 shipped in the USA, $14.78 shipped in CA with CA sales tax.

I have always hated having my oil filter just hanging from one bolt on my bumper bracket, it works but I hated it. It was not solid and could move around. I set out to design a solution. I did the R&D on my dad’s project car, I installed the prototype on my car in a matter of minutes without any plumbing changes. The bracket is designed for early bug bumper brackets (67 and earlier). This bracket is NOT designed to work with American style bumpers with overriders.

I substituted a dowel pin for one bolt because that bolt would be very hard to get to with the fender on the car. The bracket is made to work with the standard three bolt USA made filter mount/adapters. Filter mount/adapter/fittings etc. are not included with the kit. The kit includes the bracket, all hardware, and a two page instruction sheet. The bracket is made in the USA from 6061 aluminum, all the hardware is made from stainless steel.

 The mounting height is the same as hanging a standard three bolt filter mount from the 67 and earlier bug bumper bracket bolt. Most people just put a bolt through the upper hole on the filter mount and hang it from the bumper bracket bolt. I say hang because it is not solid and can move. I went with the same height/location so you (and myself) would not have to replumb to use the bracket.

Part #705 the price is $39.00 shipped in the USA , $41.71 shipped in CA with CA sales tax. See more pics in the product photo gallery.

Stainless Alternator clamp. These are made in the USA, and are much nicer than the OEM clamp/strap.

Part #706 the price is $13.00 shipped in the USA, $13.71 shipped in CA with CA sales tax.

Type 3 block off for universal cases much nicer than the stamped steel part that comes in the hardware kits. The stamped steel part is far from flat these are nice and flat no gasket needed just your sealer of choice. Made in the USA. $13.00 shipped in the USA $13.80 shipped is CA with CA sales tax. Also have these in black. More photos in the product gallery.

Fuel pump block off, made from 1/2 6061-T6 plate right here in the USA. Stainless hardware included. Also hae these in black anodize. Price is $18.00 shipped in the USA or $19.20 shipped in CA with CA sales tax.